Samsung-Galaxy S2 Plus I9105-Official-firmware-flash-file-Without-Password-100%-Tested-Free-Download By-Jualstar

Samsung-Galaxy S2 Plus I9105-Official-firmware-flash-file-Without-Password-100%-Tested-Free-Download By-Jualstar 

Samsung released a new version of the official firmware for Galaxy S2 Plus I9105, improving its already good functionality with Multilingual support for Middle East countries and countless other updates. In this tutorial we provide detailed steps for the installation of  on Galaxy S2 Plus I9105.

Browse carefully through the following recommendations, and then apply the guidelines.

• Make sure you own the mentioned smart phone, as one shouldn’t try to use this tutorial for other models;
• Back-up all personal data and settings. If not, everything will be lost after the wiping process;
• Charge the device’s battery to 80% minimum;
• Back-up EFS folder;
• Download and install the latest USB drivers for Galaxy S2 Plus I9105;
• Enable USB debugging mode on your device;
• Remember that you are the only one responsible for the eventual damaging of the smart phone. Use this at your own risk!

Now you can go for the official firmware installation on Galaxy S2 Plus I9105:

Click Here To Download  

1. I9105DDAMB2_I9105DDAMB2 zip – 718.MB

              And 4 File link.

ClickHere To Download  

 
2. Download Odin 3.07;
3. Extract the two archives you have downloaded on your PC;
4. Turn off your smart phone;
5. Simultaneously press and hold ‘Volume Down’ and ‘Home’ keys while pressing the ‘Power’ button in order to boot into Download Mode;
6. Run ODIN;
7. Connect the device to the computer via USB cable. You should now get the message ‘Added!’ in Odin and the COM port should turn yellow. If not, try reinstalling the USB drivers;
8. In ODIN, click on the following buttons and select the files from the firmware archive you downloaded and extracted:

• Click ‘PDA’ and select I9105DDAMB2_I9105DDAMB2_HOME.tar.md5 file;
• Click ‘Phone’ and select a file with ‘modem’ in its name (if there is no such a file, leave this section blank);
• Click ‘CSC’ and select the file containing ‘csc’ in its name (if there is no such a file, leave this section blank);
• Click ‘PIT’ and select the file with .pit extension (if there is no such a file, leave this section blank);

9. In ODIN, check boxes ‘Auto Reboot’ and ‘F. Reset Time’. If you have selected a .pit file, also check the ‘Re-Partition’ box;

10. Press ‘START’ in Odin;
11. After the completion of the flashing process, the device will restart and the USB cable can be unplugged safely. That’s all!